How to Build a Mousetrap Car

Things You\’ll Need

  • Mousetraps

  • Toy car wheels

  • Nails

  • Hammer

  • Straight edge

  • Tongue depressors or Popsicle sticks

  • Wood glue

  • Clothespins or clamps

  • Scrap wood blocks (1 inch x 1 inch x 1/4 inch)

  • Power drill and assorted bits

  • Wood dowel

  • Handsaw

  • Utility knife

  • Milk jug lids

  • CDs or plastic CD toppers

  • Rubber bands

  • Hot glue and glue gun

  • Fishing line

  • Pliers

... Mousetrap race car Image Credit: Megan Andersen

Making a mousetrap car is a fun way to experiment with materials around the house while learning about physics.

Video of the Day

Step 1

... Making pilot holes for the nails. Image Credit: Megan Andersen

Use a nail to press a hole in each side of the mousetrap. (These holes act as guides and help keep the wood from splitting.) Nail the toy wheels to the sides of the mousetrap at the front of the trap. Leave a little space between the trap and the wheel when you hammer in the nail, so the wheels can rotate freely.

Step 2

... Center drilled holes Image Credit: Megan Andersen

Draw two Xs on the 1-inch wood blocks, using a pencil and straight edge. At the intersection of each X, drill a hole slightly larger than the wood dowel.

Step 3

... Let the wood glue dry completely. Image Credit: Megan Andersen

Glue two Popsicle sticks to the bottom of the mousetrap, aligned with the sides of the mousetrap and extending from the end opposite the wheels. Glue the wood blocks on top of the Popsicle sticks. Hold the Popsicle sticks in place while they dry, using either clamps or clothespins. Allow the glue to cure completely (about 6 hours).

Step 4

... Carving the dowel. Image Credit: Megan Andersen

Cut a length of wood dowel about 3 inches longer than the width of the mousetrap. Carve a small notch in the center of the dowel.

Step 5

... Create the back wheels. Image Credit: Megan Andersen

Slide the wood dowel through the holes in the wood blocks. Drill a hole in the center of the milk jug lids, then slip the CD toppers and milk jug lids onto the dowel. Wrap rubber bands around the dowels to secure the assembly.

Step 6

... Hot glue the rubber bands in place. Image Credit: Megan Andersen

Apply a generous amount of hot glue inside the milk jug lid and around the rubber band. This will secure the "wheel" to the "axle." Be careful not to glue the CD topper to the wood blocks. You want these "back wheels" to spin freely.

Step 7

... View of the axle. Image Credit: Megan Andersen

Check to make sure both wheels spin freely. Pry away any stray glue, if necessary. Cut a piece of fishing line about 6 inches long and tie one end to the metal bar of the mousetrap.

Step 8

... Set the trap and watch the car roll. Image Credit: Megan Andersen

Pull the trap bar back toward the back wheels, and wrap the fishing line around the center of the axle and the notch. Gently place the car on a hardwood or linoleum floor, and release your hand from the trap. The car should propel forward and roll for several feet.

Tip

Using CD toppers is a way to reduce the friction between the wheel and floor. Friction will cause the car to slow down quickly, and therefore travel a shorter distance.

Warning

Be very careful when working with the mousetrap. If you look away from what you are doing during this project, you could snap your finger in the mousetrap.

Related Stories

Discover

Caught in the Middle

Caught in the MiddleHelp for the Sandwich Generation- Twenty million American adults are caring for aging parents at the same time they\'re raising young children. Known as the Sandwich Generation, the

The Importance of Senior Fitness

The Importance of Senior Fitness- According to the National Institutes of Health (NIH), exercise and physical activity are some of the best things older adults can do to stay healthy. Even moderate ex

Grandparent Getaways

Grandparent GetawaysTrips to take with your grandchildren- \"No parents allowed.\" It\'s not a sign on a kid-only clubhouse, it\'s the first rule of travel for memory-making grandparent/grandchild vacatio

Comfortably Aging in Place

Comfortably Aging in PlaceHaving lived in the same ranch house for 55 years, John Heck’s grandparents wanted to make any and all necessary accommodations to allow them to peacefully age in place. Usin

Aging with Vitality, Grace and Confidence

Aging with Vitality, Grace and ConfidenceIt’s one of the great ironies of life: Your reward for surviving the tumultuous teen years, establishing a career and nurturing a family culminates in dry skin

3 Ways Seniors Can Control Prescription Costs

3 Ways Seniors Can Control Prescription CostsFor 55 million Americans enrolled in Medicare, the New Year means any new Medicare Advantage or prescription drug plans, or any changes to your existing pl

Popular Categories